Fuel System: 1G-13
• When installing the fuel pump assembly, first tighten
all the fuel pump mounting bolts lightly and then to the
specified torque in the ascending of numbers.
Tightening torque
Fuel pump mounting bolt (a): 10 N·m (1.0 kgf-m,
7.0 lbf-ft)
Fuel Mesh Filter Inspection and Cleaning
B947H11706011
Inspect the fuel mesh filter in the following procedures:
1) Remove the fuel mesh filter. Refer to “Fuel Pump
Disassembly and Assembly” (Page 1G-11).
2) If the fuel mesh filter is clogged with foreign particles,
it hinders smooth gasoline flow resulting in loss of
engine power. Such a filter should be cleaned by
blowing with compressed air.
NOTE
When the fuel mesh filter is dirtied
excessively, replace the fuel filter cartridge
with a new one.
3) After finishing the fuel mesh filter inspection, reinstall
the fuel mesh filter. Refer to “Fuel Pump
Disassembly and Assembly” (Page 1G-11).
Fuel Injector / Fuel Delivery Pipe / T-joint
Removal and Installation
B947H11706012
Refer to “Throttle Body Disassembly and Assembly” in
Section 1D (Page 1D-11).
Fuel Injector Inspection and Cleaning
B947H11706013
Inspect the fuel injector in the following procedures:
1) Remove the fuel injector. Refer to “Throttle Body
Disassembly and Assembly” in Section 1D
(Page 1D-11).
2) Check the fuel injector for evidence of dirt and
contamination. If present, clean and check for
presence of dirt in the fuel lines and fuel tank.
3) Install the fuel injector. Refer to “Throttle Body
Disassembly and Assembly” in Section 1D
(Page 1D-11).
(1) (6)
(2)
(3)
(4)
(5)
(a)
I947H1170016-01
I947H1170017-01
I947H1170031-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
