1H-7 Ignition System:
• Install the ignition coil and connect their lead wire
couplers.
CAUTION
!
Do not hit the ignition coil with a plastic
hammer when installing it.
Spark Plug Inspection and Cleaning
B947H11806002
Refer to “Spark Plug Inspection and Cleaning” in Section
0B (Page 0B-9).
Ignition Coil Inspection
B947H11806003
Refer to “Electrical Components Location” in Section 0A
(Page 0A-7).
Ignition Coil Primary Peak Voltage
1) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation” in Section 1D
(Page 1D-7).
2) Disconnect all ignition coil. Refer to “Ignition Coil and
Spark Plug Removal and Installation” (Page 1H-6).
3) Connect the new spark plugs to each ignition coil.
4) Connect all the ignition coil lead wire couplers to the
ignition coil respectively, and ground them on the
cylinder head (each spark plug hole).
CAUTION
!
Avoid grounding the spark plugs and
suppling the electrical shock to the cylinder
head cover (magnesium parts) to prevent the
magnesium material from damage.
NOTE
Be sure that all the spark plugs are
connected properly and the battery used is in
fully-charged condition.
INCORRECT
I718H1180012-01
I947H1180009-03
1. New spark plug
“A”: Contact the spark plug to the cylinder head.
I947H1180010-03
1
“A”
I823H1180011-02
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
