6B-9 Steering / Handlebar:
Steering stem upper bracket
Install the front forks and steering stem upper bracket in
the following points:
• Temporarily install the upper bracket (1), washer (2)
and steering stem head nut (3). Refer to “Handlebar
Removal and Installation” (Page 6B-2).
• Temporarily install the front forks.
• Tighten the steering stem head nut (3) to the specified
torque.
Tightening torque
Steering stem head nut (a): 90 N·m (9.0 kgf-m,
65.0 lbf-ft)
• Tighten the front fork upper and lower clamp bolts.
Refer to “Front Fork Removal and Installation” in
Section 2B (Page 2B-2).
Steering damper
• Apply grease to the bearings and dust seals.
: Grease 99000–25010 (SUZUKI SUPER
GREASE “A” or equivalent)
• Install the steering damper and tighten the bolt (1) and
nut (2).
Tightening torque
Steering damper bolt (a): 23 N·m (2.3 kgf-m, 16.5
lbf-ft)
Steering damper nut (b): 23 N·m (2.3 kgf-m, 16.5
lbf-ft)
Inspection after installation
• Check the steering tension. Refer to “Steering Tension
Adjustment” (Page 6B-11).
Steering / Steering Damper Related Parts
Inspection
B947H16206007
Refer to “Steering / Steering Damper Removal and
Installation” (Page 6B-6).
Inspect the removed parts for the following
abnormalities:
Steering Stem
• Distortion of the steering stem and brackets.
1
2
3
2
3
1
I947H1620031-01
(a)
3
I947H1620032-01
I823H1620019-02
(b)
2
(a)
1
I947H1620033-02
I947H1620034-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
