Engine Lubrication System: 1E-9
5) Remove the oil cooler guard (4).
Installation
Install the oil cooler and oil cooler hoses in the reverse
order of removal. Pay attention to the following points:
• Apply thread lock to the oil cooler mounting bolt and
tighten them securely.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER “1322” or
equivalent)
• Apply engine oil to new O-rings.
CAUTION
!
Replace the O-rings with new ones to prevent
oil leakage.
• Apply thread lock to the oil cooler hose bolts and
tighten them securely.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER “1322” or
equivalent)
• Pour engine oil. Refer to “Engine Oil and Filter
Replacement” in Section 0B (Page 0B-10).
• Install the removed parts.
Oil Pressure Switch Removal and Installation
B947H11506007
Refer to “Electrical Components Location” in Section 0A
(Page 0A-7).
Removal
1) Turn the ignition switch OFF.
2) Remove the left side cowling. Refer to “Exterior
Parts Removal and Installation” in Section 9D
(Page 9D-6).
3) Drain engine oil. Refer to “Engine Oil and Filter
Replacement” in Section 0B (Page 0B-10).
4) Disconnect the oil pressure switch lead wire (1).
4
I947H1150017-01
I947H1150045-01
I947H1150018-01
I947H1150019-01
I947H1150044-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
