Lighting Systems: 9B-11
Turn Signal / Side-Stand Relay Inspection
B947H19206019
Refer to “Electrical Components Location” in Section 0A
(Page 0A-7).
NOTE
Make sure that the battery is fully charged.
Before removing the turn signal/side-stand relay, check
the operation of the turn signal light.
If the turn signal light does not illuminate, inspect the
bulb, turn signal switch and circuit connection.
If the bulb, turn signal switch and circuit connection are
OK, the turn signal relay may be faulty; therefore,
replace the turn signal/side-stand relay with a new one.
Refer to “Turn Signal / Side-Stand Relay Removal and
Installation” (Page 9B-11).
Turn Signal / Side-Stand Relay Removal and
Installation
B947H19206020
Removal
1) Remove the frame cover. Refer to “Exterior Parts
Removal and Installation” in Section 9D (Page 9D-
6).
2) Remove the turn signal/side-stand relay (1).
Installation
Install the turn signal/side-stand relay in the reverse
order of removal.
Hazard Switch Inspection
B947H19206021
Inspect the hazard switch in the following procedures:
1) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation” in Section 1D
(Page 1D-7).
2) Disconnect the left handlebar switch coupler (1).
(Yellow)
3) Inspect the hazard switch for continuity with the
tester.
If any abnormality is found, replace the left
handlebar switch assembly with a new one. Refer to
“Handlebar Removal and Installation” in Section 6B
(Page 6B-2).
Special tool
: 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the hazard switch inspection, reinstall
the removed parts.
1
I947H1920037-02
1
I947H1920038-01
Color
B/R Bl Dg
OFF
ON
Position
I947H1920039-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
