9B-2 Lighting Systems:
4) Remove the intake pipe covers (3).
5) Remove the intake cover (4).
6) Remove the body cowling (5).
Installation
Installation is in the reverse order of removal. Pay
attention to the following point:
• Route the wiring harness properly. Refer to “Wiring
Harness Routing Diagram” in Section 9A (Page 9A-7).
• After installing, be sure to inspect the headlight beam.
Refer to “Headlight Beam Adjustment” (Page 9B-3).
Headlight Bulb and Position Light Bulb
Replacement
B947H19206003
CAUTION
!
When you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
Low Beam Bulb
1) Remove the combination meter. Refer to
“Combination Meter Removal and Installation” in
Section 9C (Page 9C-2).
2) Disconnect the headlight (Low beam) coupler (1).
3) Remove the headlight bulb/socket (Low beam) (2)
by turning it counterclockwise.
4) Replace the headlight bulb (Low beam) with a new
one.
5) Reinstall the removed parts.
High Beam Bulb
1) Remove the body cowling cover. Refer to “Exterior
Parts Removal and Installation” in Section 9D
(Page 9D-6).
2) Disconnect the headlight (High beam) coupler (1).
3) Remove the headlight bulb/socket (High beam) (2)
by turning it counterclockwise.
4) Replace the headlight bulb (High beam) with a new
one.
5) Reinstall the removed parts.
“A”: Velcro fastening
3
I947H1920003-01
5
4
I947H1920005-01
“A”
I947H1920006-01
1
2
I947H1920007-01
1
2
I947H1920008-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
