Clutch: 5C-2
Repair Instructions
Clutch Lever Position Switch Inspection
B947H15306001
Inspect the clutch lever position switch in the following
procedures:
1) Disconnect the clutch lever position switch lead
wires (1).
2) Inspect the clutch lever position switch for continuity
with the tester.
If any abnormality is found, replace the switch with a
new one.
Special tool
: 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity ( )
Clutch lever position switch
3) Connect the clutch lever position switch lead wires.
Clutch Cable Inspection
B947H15306002
Refer to “Clutch Cable Play Inspection and Adjustment”
in Section 0B (Page 0B-14).
Clutch Cable Removal and Installation
B947H15306003
Removal
1) Remove the left side cowling. Refer to “Exterior
Parts Removal and Installation” in Section 9D
(Page 9D-6).
2) Disconnect the clutch cable from the clutch lever.
Refer to “Handlebar Removal and Installation” in
Section 6B (Page 6B-2).
3) Remove the clutch cable as shown in the throttle
cable routing diagram. Refer to “Throttle Cable
Routing Diagram” in Section 1D (Page 1D-2).
Installation
1) Install the clutch cable as shown in the throttle cable
routing diagram. Refer to “Throttle Cable Routing
Diagram” in Section 1D (Page 1D-2).
2) Reinstall the removed parts.
1
I947H1530001-02
Terminal (B/Y) Terminal (B/W)
FREE
Color
Position
I649G1530004-03
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
