4A-10 Brake Control System and Diagnosis:
Front Brake Master Cylinder Assembly Removal
and Installation
B947H14106012
Removal
1) Drain brake fluid. Refer to “Brake Fluid
Replacement” (Page 4A-6).
2) Disconnect the front brake light switch coupler (1).
3) Place a rag underneath the brake hose union bolt (2)
on the master cylinder to catch any spilt brake fluid.
4) Remove the brake hose union bolt (2).
5) Remove the master cylinder assembly.
Installation
Install the front brake master cylinder in the reverse
order of removal. Pay attention to the following points:
• When installing the master cylinder (1) onto the
handlebar, align the master cylinder holder’s mating
surface “A” with the punch mark “B” on the handlebar
and tighten the upper holder bolt first.
Tightening torque
Front brake master cylinder holder bolt (Upper
and Lower) (a): 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
1
2
I947H1410018-02
I947H1410019-02
“C”: Up mark “a”: Clearance
(a)
1
“A”
“B”
I947H1410020-01
(a)
(a)
“C”
“a”
“B”
“A”
1
I947H1410041-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
