1C-2 Engine Electrical Devices:
CMP Sensor Inspection
B947H11306002
Refer to “DTC “C11” (P0340): CMP Sensor Circuit
Malfunction” in Section 1A (Page 1A-29).
CMP Sensor Removal and Installation
B947H11306003
Removal
1) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation” in Section 1D
(Page 1D-7).
2) Remove the PAIR control solenoid valve. Refer to
“PAIR Control Solenoid Valve Removal and
Installation” in Section 1B (Page 1B-9).
3) Disconnect the coupler (1) and remove the CMP
sensor (2).
Installation
Install the CMP sensor in the reverse order of removal.
Pay attention to the following points:
CAUTION
!
When installing the CMP sensor, make sure
to clean the sensor surface.
• Tighten the CMP sensor bolt (1) to the specified
torque.
Tightening torque
CMP sensor bolt (a): 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
CKP Sensor Inspection
B947H11306004
Refer to “CKP Sensor Inspection” in Section 1H
(Page 1H-9).
CKP Sensor Removal and Installation
B947H11306005
Removal
1) Remove the clutch cover. Refer to “Clutch Removal”
in Section 5C (Page 5C-5).
2) Remove the CKP sensor (1).
Installation
Install the CKP sensor in the reverse order of removal.
Refer to “Clutch Installation” in Section 5C (Page 5C-7).
IAP Sensor Inspection
B947H11306006
Refer to “DTC “C13” (P0105-H/L): IAP Sensor Circuit
Malfunction” in Section 1A (Page 1A-35).
IAP Sensor Removal and Installation
B947H11306007
Removal
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation” in Section 1G (Page 1G-
9).
2) Disconnect the coupler (1) and vacuum hose (2).
3) Remove the IAP sensor (3) from the air cleaner box.
Installation
Install the IAP sensor in the reverse order of removal.
TP Sensor Inspection
B947H11306008
Refer to “DTC “C14” (P0120-H/L): TP Sensor Circuit
Malfunction” in Section 1A (Page 1A-43).
1
2
I947H1130004-02
(a)
1
I947H1130005-02
1
I947H1130006-01
1
2
3
I947H1130007-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk