EasyManuals Logo
Home>Suzuki>Motorcycle>GSX-R1000

Suzuki GSX-R1000 User Manual

Suzuki GSX-R1000
641 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #228 background imageLoading...
Page #228 background image
1C-4 Engine Electrical Devices:
ECT Sensor Removal and Installation
B947H11306011
Removal
1) Remove the left side cowling. Refer to “Exterior
Parts Removal and Installation” in Section 9D
(Page 9D-6).
2) Drain engine coolant. Refer to “Cooling System
Inspection” in Section 0B (Page 0B-12).
3) Disconnect the coupler and remove the ECT sensor
(1).
CAUTION
!
Take special care when handling the ECT
sensor. It may cause damage if it gets an
excessive impact.
Installation
Install the ECT sensor in the reverse order of removal.
Pay attention to the following points:
Tighten the ECT sensor (1) to the specified torque.
CAUTION
!
Use new gasket washer to prevent engine
coolant leakage.
Tightening torque
ECT sensor (a): 18 N·m (1.8 kgf-m, 13.0 lbf-ft)
Pour engine coolant. Refer to “Cooling System
Inspection” in Section 0B (Page 0B-12).
ECT Sensor Inspection
B947H11306012
Refer to “DTC “C15” (P0115-H/L): ECT Sensor Circuit
Malfunction” in Section 1A (Page 1A-50).
Inspect the ECT sensor in the following procedures:
1) Remove the ECT sensor. Refer to “ECT Sensor
Removal and Installation” (Page 1C-4).
2) Connect the ECT sensor (1) to the circuit tester and
place it in the oil (2) contained in a pan, which is
placed on a stove.
3) Heat the oil to raise its temperature slowly and read
the column thermometer (3) and ohmmeter.
If the ECT sensor ohmic value does not change in
the proportion indicated, replace it with a new one.
CAUTION
!
Take special care when handling the ECT
sensor. It may cause damage if it gets an
excessive sharp impact.
Do not contact the ECT sensor and column
thermometer with a pan.
Special tool
(A): 09900–25008 (Multi circuit tester set)
Tester knob indication
Resistance ()
ECT sensor specification
4) Install the ECT sensor. Refer to “ECT Sensor
Removal and Installation” (Page 1C-4).
1
I947H1130010-01
(a)
1
I947H1130011-01
Temperature Standard resistance
20 °C (68 °F) Approx. 2.45 k
50 °C (122 °F) Approx. 0.811 k
80 °C (176 °F) Approx. 0.318 k
110 °C (230 °F) Approx. 0.142 k
(A)
2
1
3
I718H1130014-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki GSX-R1000 and is the answer not in the manual?

Suzuki GSX-R1000 Specifications

General IconGeneral
BrandSuzuki
ModelGSX-R1000
CategoryMotorcycle
LanguageEnglish

Related product manuals