2C-13 Rear Suspension:
Plate
Inspect the plate for damage and excessive bend. If any
defect is found, replace the plate with a new one.
Swingarm Bearing
1) Insert the collars and spacer into bearings.
2) Check the play by moving the collars and spacer up
and down. If excessive play is noted, replace the
bearings with new ones. Refer to “Swingarm Bearing
Removal and Installation” (Page 2C-13).
Swingarm
Inspect the swingarm for damage. If any defect is found,
replace the swingarm with a new one.
Swingarm Pivot Shaft
Measure the swingarm pivot shaft runout using the dial
gauge. If the runout exceeds the service limit, replace
the pivot shaft.
Special tool
(A): 09900–20607 (Dial gauge)
(B): 09900–20701 (Dial gauge chuck)
(C): 09900–21304 (V blocks)
Swingarm pivot shaft runout
Service limit: 0.3 mm (0.01 in)
Swingarm Bearing Removal and Installation
B947H12306016
Removal
1) Remove the swingarm. Refer to “Swingarm Removal
and Installation” (Page 2C-9).
2) Remove the swingarm pivot bearings (1) using the
special tool.
Special tool
(A): 09921–20240 (Bearing remover set)
3) Remove the center spacer (2).
I947H1230048-01
I947H1230049-01
I947H1230050-01
(A)
(B)
(C)
I823H1230048-01
(A)
1
I947H1230051-01
2
I947H1230052-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
