9B-6 Lighting Systems:
Rear Combination Light Removal and
Installation
B947H19206009
Removal
1) Remove the frame cover assembly. Refer to
“Exterior Parts Removal and Installation” in Section
9D (Page 9D-6).
2) Remove the clamps (1).
3) Disconnect the combination light coupler (2).
4) Remove the rear combination light assembly (3).
5) Remove the combination light bracket (4).
Installation
Install the rear combination light in the reverse order of
removal. Pay attention to the following point:
• Tighten the combination light mounting bolts (1) to the
specified torque.
NOTE
When reusing the removed bolts (1), apply a
small quantity of the thread lock to them.
Tightening torque
Rear combination light mounting bolt (a): 2.8 N·m
(0.28 kgf-m, 2.0 lbf-ft)
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER “1322” or
equivalent)
Rear Combination Light Replacement
B947H19206010
CAUTION
!
If LED operation is abnormal, replace the rear
combination light with a new one.
1
2
3
I947H1920018-01
4
I947H1920019-01
(a)
1
I947H1920020-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
