1I-9 Starting System:
2) Disconnect the gear position switch coupler (1).
CAUTION
!
When disconnecting and connecting the gear
position switch coupler, make sure to turn off
the ignition switch, or electronic parts may
get damaged.
3) Check the continuity between Bl and B lead wires
with the transmission in “neutral”.
Special tool
: 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity test ( )
4) Connect the gear position switch coupler to the
wiring harness.
5) Insert the needle pointed probes to the lead wire
coupler.
6) Turn the ignition switch ON and side-stand to upright
position.
7) Measure the voltage between P and B/W lead wires
using the multi-circuit tester when shifting the
gearshift lever from low to top.
Special tool
(A): 09900–25008 (Multi circuit tester set)
(B): 09900–25009 (Needle-point probe set)
Tester knob indication
Voltage ( )
Gear position switch voltage (Except neutral
position)
0.6 V and more ((+) P – (–) B/W)
8) Turn the ignition switch OFF.
9) Install the removed parts.
Starter Torque Limiter Removal and Installation
B947H11906012
Removal
1) Remove the clutch assembly. Refer to “Clutch
Removal” in Section 5C (Page 5C-5).
2) Remove the washer (1), starter idle gear No. 1 (2)
and starter torque limiter (3).
Installation
Installation is in the reverse order of removal. Pay
attention to the following point:
• Apply molybdenum oil solution to the starter torque
limiter shaft hole.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
• Install the clutch assembly. Refer to “Clutch
Installation” in Section 5C (Page 5C-7).
1
I947H1190014-01
ON (Neutral)
OFF (Except neutral)
BI B/W
I947H1190030-01
(A)
(B)
I947H1190015-01
1
2
3
I947H1190016-01
I947H1190017-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
