9C-3 Combination Meter / Fuel Meter / Horn:
Combination Meter Disassembly and Assembly
B947H19306003
Refer to “Combination Meter Removal and Installation”
(Page 9C-2).
Disassembly
Disassemble the combination meter as shown in the
combination meter components. Refer to “Combination
Meter Components” (Page 9C-2).
Assembly
Assemble the combination meter as shown in the
combination meter components. Refer to “Combination
Meter Components” (Page 9C-2).
Combination Meter Inspection
B947H19306004
LED Inspection
Check that the LEDs “A” (FI, fuel, engine RPM, oil
pressure/engine coolant, immobilizer (E-02, 19, 24, 51)
and meter panel illumination) immediately light up when
the ignition switch is turned ON.
Check that the other LEDs “B” (neutral, high-beam and
turn signal indicator lights) light up/go off by operating
each switch.
If abnormal condition is found, replace the combination
meter assembly with a new one after checking its wire
harness/coupler. Refer to “Combination Meter Removal
and Installation” (Page 9C-2).
Stepping Motor Inspection and Adjustment
1) Check that the pointers calibrate immediately after
turning the ignition switch ON and stop at zero point.
If abnormal condition is found, replace the
combination meter assembly with a new one after
checking its wire harness/coupler.
NOTE
• The pointers may not return to the proper
position even turning the ignition switch
on under low temperature condition. In
that case, you can reset the pointers to the
proper position by the following
instruction.
• Complete the operation within 10 seconds
after the ignition switch has been turned
on.
2) With the ADJ button (1) pressed, turn the ignition
switch ON.
3) Keep pushing the ADJ button for more than 3 to 5
sec.
4) Release the ADJ button, then tap it twice.
Pointers will return to the proper position right after
the completion of the operation. In the case of the
pointers not returning to the proper position after
doing above, replace the combination meter unit.
Refer to “Combination Meter Removal and
Installation” (Page 9C-2).
“A”
“A”
“B”
“B”
“B”
I947H1930005-01
I947H1930006-02
1
I947H1930007-02
Time Ignition switch Adjuster button (1)
PUSH
Release
Push
Push→Reset
OFF
ON
0
•
•
•
•
•
•
3 sec.
•
5 sec.
10 sec.
I837H1930023-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
