Engine Mechanical: 1D-35
• Tighten the cylinder head cover bolts to the specified
torque in two steps.
Tightening torque
Cylinder head cover bolt (Initial): 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
Cylinder head cover bolt (Final): 14 N·m (1.4 kgf-
m, 10.0 lbf-ft)
• Install the spark plugs. Refer to “Ignition Coil and
Spark Plug Removal and Installation” in Section 1H
(Page 1H-6).
Cylinder Head Cover Disassembly and
Assembly
B947H11406045
Disassembly
1) Remove the cylinder head cover. Refer to “Engine
Top Side Disassembly” (Page 1D-26).
2) Remove the gaskets (1) and (2).
3) Remove the PAIR control solenoid valve (3) along
with the PAIR reed valve covers (4).
4) Remove the PAIR reed valves (5) and CMP sensor
(6).
Assembly
Assembly is in the reverse order of disassembly. Pay
attention to the following points:
• Install the CMP sensor.
NOTE
When installing the CMP sensor, clean the
sensor surface.
• Tighten the CMP sensor bolt (1) to the specified
torque.
Tightening torque
CMP sensor bolt (a): 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
• Install the PAIR reed valves.
I947H1140063-02
1
2
I947H1140100-01
4
3
I947H1140102-02
5
6
I947H1140103-02
(a)
1
I947H1140105-02
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
