Engine Mechanical: 1D-65
• Apply engine oil to the bearing (7) and spacer (8) and
install them into the sprocket.
Oil Strainer / Oil Pressure Regulator
• Apply grease to new O-ring (1).
CAUTION
!
Use a new O-ring to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE “A” or equivalent)
• Install the oil strainer (2).
• Apply grease to new O-ring (3).
CAUTION
!
Use a new O-ring to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE “A” or equivalent)
• Push in the oil pressure regulator (4) to the oil pump
as shown.
Oil Pan
• Install new gasket.
CAUTION
!
Use new gasket to prevent oil leakage.
• Install the oil pan (1) and plate (2).
• Apply thread lock to the plate bolts “A”.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER “1322” or
equivalent)
• Tighten the oil pan bolts and plate bolts diagonally to
the specified torque.
Tightening torque
Oil pan bolt: 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
Oil Filter
Install the oil filter with the special tool. Refer to “Engine
Oil and Filter Replacement” in Section 0B (Page 0B-10).
Special tool
(A): 09915–40610 (Oil filter wrench)
7
8
I947H1140196-01
1
2
I947H1140197-01
3
4
I947H1140198-02
2
1
“A”
I947H1140298-01
(A)
I947H1140201-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk