Emission Control Devices: 1B-11
Crankcase Breather (PCV) Hose Inspection
B947H11206006
Inspect the crankcase breather (PCV) hose in the
following procedures:
1) Lift and support the fuel tank with the prop stay.
Refer to “Fuel Tank Removal and Installation” in
Section 1G (Page 1G-9).
2) Inspect the crankcase breather (PCV) hose (1) for
wear and damage.
If it is worn or damaged, replace the crankcase
breather (PCV) hose with a new one.
3) Check that the crankcase breather (PCV) hose (1) is
securely connected.
4) Install the removed parts.
Crankcase Breather (PCV) Hose / Reed Valve /
Cover Removal and Installation
B947H11206007
Removal
1) Lift and support the fuel tank with the prop stay.
Refer to “Fuel Tank Removal and Installation” in
Section 1G (Page 1G-9).
2) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation” in Section 1D
(Page 1D-7).
3) Disconnect the crankcase breather (PCV) hose (1).
4) Remove the crankcase breather (PCV) cover (2).
Installation
Installation is in the reverse order of removal.
Pay attention to the following points:
• Apply bond to the hatching part of crankcase breather
(PCV) cover.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
• Fit the clamp to the bolt “A”.
• Connect the crankcase breather (PCV) hose securely.
Refer to “Throttle Body Construction” in Section 1D
(Page 1D-9).
1
I947H1120022-01
1
I947H1120023-01
2
I947H1120024-02
I947H1140293-01
“A”
I947H1120025-03
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
