1F-9 Engine Cooling System:
4) Disconnect the reservoir tank overflow hose (3).
Installation
1) Install the reservoir tank. Refer to “Radiator / Cooling
Fan Motor Removal and Installation” (Page 1F-6).
2) Fill the reservoir tank with engine coolant to the
upper level. Refer to “Cooling System Inspection” in
Section 0B (Page 0B-12).
3) Install the right side cowling. Refer to “Exterior Parts
Removal and Installation” in Section 9D (Page 9D-
6).
Cooling Fan Inspection
B947H11606009
Cooling fan operating temperature
Standard
(ON → OFF): Approx. 100 °C (212 °F)
(OFF → ON): Approx. 105 °C (221 °F)
Inspect the cooling fan in the following procedures:
1) Disconnect the cooling fan motor coupler (1).
2) Test the cooling fan motor for load current with an
ammeter connected as shown in the figure.
If the fan motor does not turn, replace the cooling fan
assembly with a new one. Refer to “Radiator /
Cooling Fan Motor Removal and Installation”
(Page 1F-6).
NOTE
• When making this test, it is not necessary
to remove the cooling fan.
• Make sure that the battery has a capacity
enough to supply the motor with 12 V.
• With the motor running at full speed, the
ammeter should indicate an amperage not
higher than 5 A.
3) Connect the cooling fan motor coupler.
Cooling Fan Relay Inspection
B947H11606010
Inspect the fan relay in the following procedures:
1) Remove the frame covers. Refer to “Exterior Parts
Removal and Installation” in Section 9D (Page 9D-
6).
2) Remove the cooling fan relay (1).
1
2
3
I947H1160018-03
1
I947H1160019-01
2. Fan motor 3. Ammeter 4. Battery
2
3
4
I718H1160048-01
1
I947H1160052-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
