1D-34 Engine Mechanical:
• Tighten the cam chain tension adjuster service cap (6)
to the specified torque.
CAUTION
!
Use a new gasket to prevent oil leakage.
Tightening torque
Cam chain tension adjuster service cap (b): 23
N·m (2.3 kgf-m, 16.5 lbf-ft)
• Tighten the valve timing inspection cap (7) to the
specified torque.
CAUTION
!
Use a new O-ring to prevent oil leakage.
Tightening torque
Valve timing inspection cap (c): 11 N·m (1.1 kgf-
m, 8.0 lbf-ft)
Cylinder Head Cover
• Check and adjust the valve clearance. Refer to “Valve
Clearance Inspection and Adjustment” in Section 0B
(Page 0B-5).
• Pour engine oil in each oil pocket on the cylinder
head.
• Install the dowel pins and O-rings.
CAUTION
!
Replace the O-rings with new ones.
• Install new gaskets to the cylinder head cover.
• Apply bond to the cam end cap points of the gasket as
shown.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
CAUTION
!
Use new gaskets to prevent oil leakage.
• Place the cylinder head cover on the cylinder head.
• Fit a new gasket (1) to each head cover bolt.
CAUTION
!
Use new gaskets to prevent oil leakage.
• Apply engine oil to both sides of the gaskets.
(b)
6
(c)
7
I947H1140059-01
I947H1140060-01
I947H1140061-01
1
I947H1140062-03
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
