1F-7 Engine Cooling System:
7) Remove the oil cooler (6) from the bracket.
8) Remove the radiator assembly by removing the
bolts.
9) Remove the radiator outlet hose (7) and cooling fan
motor (8) from the radiator.
Installation
Install the radiator in the reverse order of removal. Pay
attention to the following points:
• Install the radiator and oil cooler to their bracket. Refer
to “Radiator Inspection and Cleaning” (Page 1F-5).
• Apply thread lock to the reservoir tank bolt and tighten
it securely.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER “1322” or
equivalent)
• Connect the radiator hoses securely. Refer to “Water
Hose Routing Diagram” (Page 1F-3).
• Pour engine coolant. Refer to “Cooling System
Inspection” in Section 0B (Page 0B-12).
• Bleed air from the cooling circuit. Refer to “Cooling
System Inspection” in Section 0B (Page 0B-12).
Water Hose Inspection
B947H11606005
Inspect the water hoses in the following procedures:
1) Remove the side cowlings. Refer to “Exterior Parts
Removal and Installation” in Section 9D (Page 9D-
6).
2) Check the water hoses for crack, damage or engine
coolant leakage. If any defect is found, replace the
water hose with a new one.
6
I947H1160010-01
I947H1160011-01
I947H1160012-02
7
8
I947H1160013-01
I947H1160058-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
