Clutch: 5C-14
8) Tighten the lock-nut (1).
Tightening torque
Clutch lifter pin lock-nut (b): 23 N·m (2.3 kgf-m,
16.5 lbf-ft)
Specifications
Service Data
B947H15307001
Clutch
Unit: mm (in)
Tightening Torque Specifications
B947H15307002
NOTE
The specified tightening torque is described in the following.
“Clutch Control System Components” (Page 5C-3)
“Clutch Components” (Page 5C-4)
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List” in Section 0C
(Page 0C-9).
(A)
(A)
I837H1530046-02
2
(b)
1
I947H1530041-02
Item Standard Limit
Clutch drive plate thickness No. 1 and 2 3.22 – 3.38 (0.127 – 0.133) 2.92 (0.115)
Clutch drive plate claw width No. 1 and 2 13.7 – 13.8 (0.539 – 0.543) 12.9 (0.508)
Clutch driven plate distortion — 0.10 (0.004)
Clutch spring free length 58.18 (2.29) 55.3 (2.18)
Clutch lifter pin height 0.2 – 0.4 (0.008 – 0.016) —
Wave spring washer height — 4.30 (0.169)
Clutch lever play 10 – 15 (0.4 – 0.6) —
Clutch release screw 1 turn back —
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Clutch sleeve hub nut 95 9.5 68.7 )(Page 5C-8)
Clutch spring set bolt
10 1.0 7.0
)(Page 5C-10) /
)(Page 5C-13)
Clutch release adjusting screw lock-nut 6 0.6 4.5 )(Page 5C-10)
Clutch lifter pin lock-nut 23 2.3 16.5 )(Page 5C-14)
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
