Manual Transmission: 5B-5
3) Remove the gearshift shaft bearings (3) and (4) with
the special tool.
Special tool
(C): 09921–20240 (Bearing remover set)
4) Remove the driveshaft left bearing with the special
tool.
Special tool
(D): 09913–70210 (Bearing installing set (10
– 75 Φ))
5) Remove the driveshaft left bearing oil seal from the
retainer using the special tool.
Special tool
(D): 09913–70210 (Bearing installing set (10
– 75 Φ))
Transmission Installation
B947H15206003
Install the transmission in the reverse order of removal.
Pay attention to the following points:
Bearing and Oil Seal
CAUTION
!
Replace the removed bearings and oil seals
with new ones.
• Install the driveshaft left bearing oil seal into the
retainer using the special tool.
Special tool
(A): 09913–70210 (Bearing installing set (10
– 75 Φ))
• Install the driveshaft left bearing with the special tool.
NOTE
The stamped mark side of the driveshaft left
bearing faces outside.
Special tool
(A): 09913–70210 (Bearing installing set (10
– 75 Φ))
4
3
(C)
(C)
I947H1520033-01
(D)
I947H1520034-01
(D)
I947H1520035-01
(A)
I947H1520036-01
(A)
I947H1520037-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
