Engine Cooling System: 1F-14
• Install the water pump assembly with the slot of the
pump shaft end “A” securely engaged with the flat “B”
of the oil pump shaft.
• Tighten the water pump mounting bolts (1) to the
specified torque.
Tightening torque
Water pump mounting bolt (a): 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
• Connect the water hoses securely. Refer to “Water
Hose Routing Diagram” (Page 1F-3).
• Pour engine oil and coolant. Refer to “Engine Oil and
Filter Replacement” in Section 0B (Page 0B-10) and
“Cooling System Inspection” in Section 0B (Page 0B-
12).
• Bleed air from the cooling circuit. Refer to “Cooling
System Inspection” in Section 0B (Page 0B-12).
Water Pump Disassembly and Assembly
B947H11606018
Refer to “Water Pump Removal and Installation”
(Page 1F-13).
Disassembly
1) Remove the air bleeder bolt (1) if necessary.
2) Remove the water pump case screws.
3) Remove the O-ring (2).
4) Hold the impeller (3) with water pump pliers and
remove the impeller securing bolt (4).
“A”
“B”
I947H1160026-01
(a)
1
I947H1160027-03
1
I947H1160028-01
I947H1160029-01
2
I947H1160030-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
