Engine General Information and Diagnosis: 1A-53
P0115-L (Use of SDS)
Step Action Yes No
1 1) Turn the ignition switch OFF.
2) Remove the left side cowling. Refer to “Exterior Parts
Removal and Installation” in Section 9D (Page 9D-6).
3) Check the ECT sensor coupler (1) for loose or poor
contacts.
If OK, then check the ECT sensor lead wire continuity.
4) Disconnect the ECT sensor coupler.
5) Check the continuity between the B/Bl wire and ground.
If the sound is not heard from the tester, the circuit
condition is OK.
Special tool
(A): 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity test ( )
6) Connect the ECT sensor coupler.
7) Insert the needle pointed probes to the lead wire coupler.
8) Turn the ignition switch ON.
Go to Step 2. • B/Bl wire shorted to
ground.
• If wire is OK, go to
Step 2.
1
I947H1110116-01
(A)
I718H1110054-03
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
