1I-11 Starting System:
• When installing the starter clutch and CKP sensor
rotor, align the wide spline tooth of them with that of
crankshaft.
• Hold the starter clutch with the special tool and tighten
the starter clutch bolt to the specified torque.
Special tool
(A): 09930–40113 (Flywheel rotor holder)
Tightening torque
Starter clutch bolt: 54 N·m (5.4 kgf-m, 39.0 lbf-ft)
• Apply molybdenum oil solution to the starter idle gear
No. 2 bearing, shaft and shaft hole.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
Starter Clutch Inspection
B947H11906010
Refer to “Starter Clutch Removal and Installation”
(Page 1I-10).
Starter Clutch
1) Install the starter driven gear onto the starter clutch.
2) Turn the starter driven gear by hand to inspect the
starter clutch for a smooth movement. The gear
turns in one direction only. If a large resistance is felt
for rotation, inspect the starter clutch or the starter
clutch contacting surface on the starter driven gear
for wear or damage.
If they are found to be damaged, replace them with
new ones.
Starter Clutch Bearing and Starter Driven Gear
Inspect the starter clutch bearing and starter clutch
contacting surface on the starter driven gear for wear
and damage. If they are found to be damaged, replace
them with new ones.
I947H1190022-01
(A)
I947H1190023-01
I947H1190024-01
I947H1190025-02
I947H1190026-02
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
