1D-38 Engine Mechanical:
7) If the camshaft journal oil clearance exceeds the
limit, measure the inside diameter of the camshaft
journal holder and the outside diameter of the
camshaft journal. Replace the camshaft or the
cylinder head depending upon which one exceeds
the specification.
Special tool
(C): 09900–20602 (Dial gauge)
(D): 09900–22403 (Small bore gauge (18 –
35 mm))
(E): 09900–20205 (Micrometer (0 – 25 mm))
Camshaft journal holder I.D. (IN. & EX.)
Standard: 24.012 – 24.025 mm (0.9454 – 0.9459
in)
Camshaft journal O.D. (IN. & EX.)
Standard: 23.959 – 23.980 mm (0.9433 – 0.9441
in)
Camshaft Sprocket
B947H11406022
Inspect the camshaft sprocket in the following
procedures:
1) Remove the intake and exhaust camshafts. Refer to
“Engine Top Side Disassembly” (Page 1D-26).
2) Inspect the teeth of each camshaft sprocket for wear
or damage.
If they are worn or damaged, replace the sprocket/
camshaft assembly and cam chain as a set.
3) Install the camshafts. Refer to “Engine Top Side
Assembly” (Page 1D-28).
Cam Chain Tension Adjuster Inspection
B947H11406023
The cam chain tension adjuster is maintained to proper
tension automatically.
1) Remove the cam chain tension adjuster. Refer to
“Engine Top Side Disassembly” (Page 1D-26).
2) Holding the cam chain tension adjuster as shown in
the figure, compress the plunger by turning the
adjuster body until the outer circlip “A” reaches the
groove “B”.
(C)
(D)
I947H1140068-01
(E)
I649G1140204-03
I947H1140069-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
