2C-3 Rear Suspension:
Rear Shock Absorber Removal and Installation
B947H12306003
Removal
1) Remove the right side cowling and side frame
covers. Refer to “Exterior Parts Removal and
Installation” in Section 9D (Page 9D-6).
2) Support the motorcycle with a jack to relieve load on
the rear shock absorber.
3) Remove the left muffler and muffler chamber heat
guard No. 2. Refer to “Muffler / Muffler Chamber /
Exhaust Pipe Removal and Installation” in Section
1K (Page 1K-11).
4) Remove the rear shock absorber lower mounting
bolt and nut (1).
5) Remove the rear shock absorber upper mounting
bolt and nut (2).
6) Remove the rear shock absorber upward.
Installation
Install the rear shock absorber in the reverse order of
removal. Pay attention to the following points:
• Tighten the rear shock absorber upper/lower
mounting bolts and nuts.
Tightening torque
Rear shock absorber upper mounting nut (a): 50
N·m (5.0 kgf-m, 36.0 lbf-ft)
Rear shock absorber lower mounting nut (b): 50
N·m (5.0 kgf-m, 36.0 lbf-ft)
• Install the left muffler and muffler chamber heat guard
No. 2. Refer to “Muffler / Muffler Chamber / Exhaust
Pipe Removal and Installation” in Section 1K
(Page 1K-11).
• Install the side frame covers and right side cowling.
Refer to “Exterior Parts Removal and Installation” in
Section 9D (Page 9D-6).
Rear Suspension Inspection
B947H12306004
Refer to “Rear Suspension Inspection” in Section 0B
(Page 0B-19).
1
I947H1230003-02
2
I947H1230004-02
I947H1230005-01
(a)
I947H1230006-01
(b)
I947H1230007-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
