Combination Meter / Fuel Meter / Horn: 9C-4
Engine Coolant Temperature Indicator Light Inspection
B947H19306005
Inspect the engine coolant temperature meter and indicator light (LED) in the following procedures:
1) Remove the left side cowling. Refer to “Exterior Parts Removal and Installation” in Section 9D (Page 9D-6).
2) Disconnect the ECT sensor coupler (1).
3) Connect a variable resistor (2) between the terminals.
4) Turn the ignition switch ON.
5) Check the engine coolant temperature meter (LCD) (3) and indicator light (LED) (4) operations when the
resistance is adjusted to the specified values.
If either one or both indications are abnormal, replace the combination meter assembly with a new one. Refer to
“Combination Meter Removal and Installation” (Page 9C-2).
6) Connect the ECT sensor coupler.
7) Install the removed parts.
ECT Sensor Removal and Installation
B947H19306006
Refer to “ECT Sensor Removal and Installation” in Section 1C (Page 1C-4).
Resistance “A”
LCD (3)
LED (4) LCD (5) Engine coolant temperature
°C °F
2.45 kΩ and more “- - -” “- - -” OFF — 19 °C (67 °F) and below
Approx. 0.318 kΩ “80” “177” OFF — Approx. 80 °C (177 °F)
0.1108 kΩ and less “120” – “139” flicker “248” – “282” flicker ON Flicker 120 – 139 °C (248 – 282 °F)
0 Ω (Jumper wire) “HI” “HI” ON Flicker 140 °C (283 °F) and over
1
I947H1930008-01
2
I718H1930009-05
3
4
5
I947H1930009-02
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
