1D-56 Engine Mechanical:
2) Remove the oil gallery plug (4) from the upper
crankcase.
Water Jacket Plug
Remove the water jacket plugs (1) from the upper
crankcase.
Oil Seal / Bearing
Remove the oil seal and bearings if necessary. Refer to
“Transmission Removal” in Section 5B (Page 5B-3).
Breather Oil Return Plate
Remove the breather oil return plate (1) from the upper
crankcase.
Engine Bottom Side Assembly
B947H11406032
Assemble the engine bottom side in the reverse order of
disassembly. Pay attention to the following points:
NOTE
Apply engine oil to each running and sliding
part before reassembling.
Breather Oil Return Plate
When installing the breather oil return plate (1), apply
thread lock to the bolts.
: Thread lock cement 99000–32110 (THREAD
LOCK CEMENT SUPER “1322” or equivalent)
Oil Seal / Bearing
Install the oil seal and bearings. Refer to “Transmission
Installation” in Section 5B (Page 5B-5).
Water Jacket Plug
• Apply engine coolant to the O-rings of the water jacket
plugs.
4
I947H1140149-01
1
1
I947H1140150-01
I947H1140151-01
I947H1140152-01
1
I947H1140153-01
1
I947H1140154-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
