1J-12 Charging System:
Installation
Install the battery in the reverse order of removal.
Pay attention to following points:
CAUTION
!
Never use anything except the specified
battery.
• Tighten the battery lead wire bolts securely.
Battery Visual Inspection
B947H11A06011
Inspect the battery in the following procedures:
1) Remove the front seat. Refer to “Exterior Parts
Removal and Installation” in Section 9D (Page 9D-
6).
2) Visually inspect the surface of the battery container.
If any signs of cracking or electrolyte leakage from
the sides of the battery have occurred, replace the
battery with a new one.
If the battery terminals are found to be coated with
rust or an acidic white powdery substance, clean the
battery terminals with sandpaper.
3) Install the front seat. Refer to “Exterior Parts
Removal and Installation” in Section 9D (Page 9D-
6).
Specifications
Service Data
B947H11A07001
Electrical
Unit: mm
CAUTION
!
Never use anything except the specified battery.
Tightening Torque Specifications
B947H11A07002
NOTE
The specified tightening torque is described in the following.
“Regulator / Rectifier Construction” (Page 1J-7)
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List” in Section 0C
(Page 0C-9).
I947H11A0018-01
Item Specification Note
Generator coil resistance 0.12 – 0.6 Ω
Generator maximum output Approx. 375 W at 5 000 r/min
Generator no-load voltage (When
engine is cold)
85 V (AC) and more at 5 000 r/min
Regulated voltage 14.0 – 15.5 V at 5 000 r/min
Battery
Type designation FT12A-BS
Capacity 12 V 36.0 kC (10 Ah)/10 HR
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Generator stator set bolt 11 1.1 8.0 )(Page 1J-5)
Generator lead wire set bolt 5.5 0.55 4.0 )(Page 1J-5)
Generator rotor bolt 145 14.5 105.0 )(Page 1J-6)
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
