Wiring Systems: 9A-8
6
7
Upside
“B”
1
“A”
“D”
“E”
3
4
5
12
16
13
15
14
17
“a”
2
11
13
14
9
8
9
10
“C”
I947H1910908-03
1. Clamp
: Pass the side-stand switch lead wire left side of the water by-
pass hose and clamp them in this range. Cut off the excess tip
of the clamp.
13. Battery negative lead wire
: Pass the battery negative lead wire in front of the PCV hose. (For E-33, pass
the lead wire below the EVAP solenoid hoses, and between the EVAP solenoid
lead wire and wiring harness.)
2. Clamp
: Bind the lead wires at the blue taping point and face the clamp
end to the engine side.
14. Rear brake light switch lead wire
: Pass the rear brake light switch lead wire below the wiring harness and battery
negative lead wire at the frame bridge part, then above the wiring harness at
the fuel tank rail part. (For E-33, pass the brake light switch lead wire between
EVAP solenoid bracket and frame.)
3. IAT sensor 15. Crankcase breather (PCV) hose
4. ISC valve 16. Starter motor lead wire
5. Clamp
: Bind the lead wires with throttle body at blue taping point and
face the clamp end forward.
17. CKP sensor lead wire
: Route the CKP sensor lead wire in front of the PCV hose and above the
battery negative lead wire.
6. White coupler (for ignition coil #1) “A”: Pass the side-stand switch lead wire between the water hoses.
7. Clamp:
Face the clamp end upward.
“B”: Plate the joint coupler to the engine side and pass the side-stand switch lead
wire and speed sensor lead wire left side of the water by-pass hose.
8. STVA lead wire “C”: Pass the rear brake light switch lead wire between the frame and drain hose,
and under the clamp.
9. Wiring harness “D”: Pass the CMP sensor lead wire between ignition coil #1 and #2.
10. ISC valve lead wire “E”: Pass the wiring harness above the air cleaner duct.
11. Regulator/rectifier lead wire “a”: 60 ± 5°
12. EVAP system purge control solenoid valve lead wire (E-33 only)
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
