Cisco Catalyst 3650 Series User Manual

traceroute mac ip
To display the Layer 2 path taken by the packets from the specified source IP address or hostname to the
specified destination IP address or hostname, use the traceroute mac ip command in privileged EXEC mode.
traceroute mac ip {source-ip-address | source-hostname} {destination-ip-address | destination-hostname}
[detail]
Syntax Description
The IP address of the source device as a 32-bit quantity in
dotted-decimal format.
source-ip-address
The IP hostname of the source device.
source-hostname
The IP address of the destination device as a 32-bit quantity in
dotted-decimal format.
destination-ip-address
The IP hostname of the destination device.
destination-hostname
(Optional) Specifies that detailed information appears.detail
Command Default
No default behavior or values.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
For Layer 2 traceroute to function properly, Cisco Discovery Protocol (CDP) must be enabled on each device
in the network. Do not disable CDP.
When the device detects a device in the Layer 2 path that does not support Layer 2 traceroute, the device
continues to send Layer 2 trace queries and lets them time out.
The maximum number of hops identified in the path is ten.
The traceroute mac ip command output shows the Layer 2 path when the specified source and destination
IP addresses are in the same subnet.
When you specify the IP addresses, the device uses Address Resolution Protocol (ARP) to associate the IP
addresses with the corresponding MAC addresses and the VLAN IDs.
•
If an ARP entry exists for the specified IP address, the device uses the associated MAC address and
identifies the physical path.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
976
traceroute mac ip

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English