Cisco Catalyst 3650 Series User Manual

ip wccp
To enable the web cache service, and specify the service number that corresponds to a dynamic service that
is defined by the application engine, use the ip wccp global configuration command on the device. Use the
no form of this command to disable the service.
ip wccp {web-cache | service-number} [group-address groupaddress] [group-list access-list] [redirect-list
access-list] [password encryption-number password]
no ip wccp {web-cache | service-number} [group-address groupaddress] [group-list access-list] [redirect-list
access-list] [password encryption-number password]
Syntax Description
Specifies the web-cache service (WCCP Version 1 and Version 2).web-cache
Dynamic service identifier, which means the service definition is
dictated by the cache. The dynamic service number can be from 0 to
254. The maximum number of services is 256, which includes the
web-cache service specified with the web-cache keyword.
service-number
(Optional) Specifies the multicast group address used by the devices
and the application engines to participate in the service group.
group-address groupaddress
(Optional) If a multicast group address is not used, specifies a list of
valid IP addresses that correspond to the application engines that are
participating in the service group.
group-list access-list
(Optional) Specifies the redirect service for specific hosts or specific
packets from hosts.
redirect-list access-list
(Optional) Specifies an encryption number. The range is 0 to 7. Use
0 for not encrypted, and use 7 for proprietary. Also, specifies a
password name up to seven characters in length. The device combines
the password with the MD5 authentication value to create security
for the connection between the device and the application engine.
By default, no password is configured, and no authentication is
performed.
password encryption-number
password
Command Default
WCCP services are not enabled on the device.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE
3.3SE
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
488
ip wccp

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English