Cisco Catalyst 3650 Series User Manual

dot1x test eapol-capable
To monitor IEEE 802.1x activity on all the switch ports and to display information about the devices that are
connected to the ports that support IEEE 802.1x, use the dot1x test eapol-capable command in privileged
EXEC mode on the switch stack or on a standalone switch.
dot1x test eapol-capable [interface interface-id]
Syntax Description
(Optional) Port to be queried.
interface interface-id
Command Default
There is no default setting.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Use this command to test the IEEE 802.1x capability of the devices connected to all ports or to specific ports
on a switch.
There is not a no form of this command.
Examples
This example shows how to enable the IEEE 802.1x readiness check on a switch to query a port. It also shows
the response received from the queried port verifying that the device connected to it is IEEE 802.1x-capable:
Device# dot1x test eapol-capable interface gigabitethernet1/0/13
DOT1X_PORT_EAPOL_CAPABLE:DOT1X: MAC 00-01-02-4b-f1-a3 on gigabitethernet1/0/13 is EAPOL
capable
Related Commands
DescriptionCommand
Configures the timeout used to wait for EAPOL
response to an IEEE 802.1x readiness query.
dot1x test timeout timeout
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
752
dot1x test eapol-capable

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English