Cisco Catalyst 3650 Series User Manual

show interfaces transceiver
To display the physical properties of a small form-factor pluggable (SFP) module interface, use the show
interfaces transceiver command in EXEC mode.
show interfaces [interface-id] transceiver [detail| module number| properties| supported-list|
threshold-table]
Syntax Description
(Optional) ID of the physical interface, including type, stack member
(stacking-capable switches only) module, and port number.
interface-id
(Optional) Displays calibration properties, including high and low numbers
and any alarm information for any Digital Optical Monitoring (DoM)-capable
transceiver if one is installed in the switch.
detail
(Optional) Limits display to interfaces on module on the switch.
The range is 1 to 9.
This option is not available if you entered a specific interface ID.
module number
(Optional) Displays speed, duplex, and inline power settings on an interface.properties
(Optional) Lists all supported transceivers.supported-list
(Optional) Displays alarm and warning threshold table.threshold-table
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Examples
This is an example of output from the show interfaces interface-id transceiver properties command:
Device# show interfaces gigabitethernet1/1/1 transceiver properties
Name : Gi1/1/1
Administrative Speed: auto
Operational Speed: auto
Administrative Duplex: auto
Administrative Power Inline: enable
Operational Duplex: auto
Administrative Auto-MDIX: off
Operational Auto-MDIX: off
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
86
show interfaces transceiver

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English