glbp weighting track
To specify a tracking object where the Gateway Load Balancing Protocol (GLBP) weighting changes based
on the availability of the object being tracked, use the glbp weighting track command in interface configuration
mode. To remove the tracking, use the no form of this command.
glbp group weighting track object-number [decrement value]
no glbp group weighting track object-number [decrement value]
Syntax Description
GLBP group number in the range from 0 to 1023.
group
Object number representing an item to be tracked.
The valid range is 1 to 1000. Use the track command
to configure the tracked object.
object-number
(Optional) Specifies an amount by which the GLBP
weighting for the device is decremented (or
incremented) when the interface goes down (or comes
back up). The value range is from 1 to 254, with a
default value of 10.
decrement value
Command Default
Objects are not tracked for GLBP weighting changes.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced..Cisco IOS XE Release 2.1
Usage Guidelines
This command ties the weighting of the GLBP gateway to the availability of its interfaces. It is useful for
tracking interfaces that are not configured for GLBP.
When a tracked interface goes down, the GLBP gateway weighting decreases by 10. If an interface is not
tracked, its state changes do not affect the GLBP gateway weighting. For each GLBP group, you can configure
a separate list of interfaces to be tracked.
The optional value argument specifies by how much to decrement the GLBP gateway weighting when a
tracked interface goes down. When the tracked interface comes back up, the weighting is incremented by the
same amount.
When multiple tracked interfaces are down, the configured weighting decrements are cumulative.
Use the track command to configure each interface to be tracked.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
164
glbp weighting track
To Next Page
Loading...
Need help?
General