snmp-server host
To specify the recipient (host) of a Simple Network Management Protocol (SNMP) notification operation,
use the snmp-server host global configuration command on the device. Use the no form of this command to
remove the specified host.
snmp-server host {host-addr } [vrf vrf-instance ] [informs | traps] [version {1 | 2c | 3 {auth | noauth |
priv} } ] {community-string [notification-type] }
no snmp-server host {host-addr } [vrf vrf-instance ] [informs | traps] [version {1 | 2c | 3 {auth | noauth
| priv} } ] {community-string [notification-type] }
Syntax Description
Name or Internet address of the host (the targeted recipient).
host-addr
(Optional) Specifies the virtual private network (VPN) routing instance and name for this
host.
vrf vrf-instance
(Optional) Sends SNMP traps or informs to this host.informs | traps
(Optional) Specifies the version of the SNMP used to send the traps.
1—SNMPv1. This option is not available with informs.
2c—SNMPv2C.
3—SNMPv3. One of the authorization keywords (see next table row) must follow the
Version 3 keyword.
version 1 | 2c |
3
auth (Optional)—Enables Message Digest 5 (MD5) and Secure Hash Algorithm (SHA)
packet authentication.
noauth (Default)—The noAuthNoPriv security level. This is the default if the auth |
noauth | priv keyword choice is not specified.
priv (Optional)—Enables Data Encryption Standard (DES) packet encryption (also called
privacy).
auth | noauth |
priv
Password-like community string sent with the notification operation. Though you can set
this string by using the snmp-server host command, we recommend that you define this
string by using the snmp-server community global configuration command before using
the snmp-server host command.
The @ symbol is used for delimiting the context information. Avoid using the @
symbol as part of the SNMP community string when configuring this command.
Note
community-string
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
560
snmp-server host
To Next Page
Loading...
Need help?
General