Examples
This example shows how to set 802.1x as the first authentication method and web authentication as the second
authentication method:
Device(config-if)# authentication priority dotx webauth
This example shows how to set MAB as the first authentication method and web authentication as the second
authentication method:
Device(config-if)# authentication priority mab webauth
Related Commands
DescriptionCommand
Configures the port mode as unidirectional or bidirectional.authentication
control-direction
Specifies how the Auth Manager handles authentication failures as a result
of unrecognized user credentials.
authentication event fail
Specifies how the Auth Manager handles authentication failures as a result
of a nonresponsive host.
authentication event
no-response action
Reinitializes an authorized Auth Manager session when a previously
unreachable authentication, authorization, and accounting server becomes
available.
authentication event server
alive action reinitialize
Authorizes Auth Manager sessions when the authentication, authorization,
and accounting server becomes unreachable.
authentication event server
dead action authorize
Enables a web authentication fallback method.authentication fallback
Allows hosts to gain access to a controlled port.authentication host-mode
Enables open access on a port.authentication open
Specifies the order in which the Auth Manager attempts to authenticate a
client on a port.
authentication order
Enables automatic reauthentication on a port.authentication periodic
Configures the authorization state of a controlled port.authentication port-control
Configures the time after which an inactive Auth Manager session is
terminated.
authentication timer inactivity
Specifies the period of time between which the Auth Manager attempts to
reauthenticate authorized ports.
authentication timer
reauthenticate
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
719
authentication priority
To Next Page
Loading...
Need help?
General