Cisco Catalyst 3650 Series User Manual

When you enable debugging on a switch stack, it is enabled only on the active switch. To enable debugging
on a stack member, you can start a session from the active switch by using the session switch-number EXEC
command. Then enter the debug command at the command-line prompt of the stack member.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
30
debug ilpower

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English