Cisco Catalyst 3650 Series User Manual

debug sw-vlan notification
To enable debugging of VLAN manager notifications, use the debug sw-vlan notification command in
privileged EXEC mode. To disable debugging, use the no form of this command.
debug sw-vlan notification {accfwdchange| allowedvlancfgchange| fwdchange| linkchange| modechange|
pruningcfgchange| statechange}
no debug sw-vlan notification {accfwdchange| allowedvlancfgchange| fwdchange| linkchange|
modechange| pruningcfgchange| statechange}
Syntax Description
Displays debug messages for VLAN manager notification of aggregated
access interface spanning-tree forward changes.
accfwdchange
Displays debug messages for VLAN manager notification of changes to the
allowed VLAN configuration.
allowedvlancfgchange
Displays debug messages for VLAN manager notification of spanning-tree
forwarding changes.
fwdchange
Displays debug messages for VLAN manager notification of interface
link-state changes.
linkchange
Displays debug messages for VLAN manager notification of interface mode
changes.
modechange
Displays debug messages for VLAN manager notification of changes to the
pruning configuration.
pruningcfgchange
Displays debug messages for VLAN manager notification of interface state
changes.
statechange
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
The undebug sw-vlan notification command is the same as the no debug sw-vlan notification command.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
1012
debug sw-vlan notification

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English