Cisco Catalyst 3650 Series User Manual

show power inline
To display the Power over Ethernet (PoE) status for the specified PoE port, the specified stack member, or
for all PoE ports in the switch stack, use the show power inline command in EXEC mode.
show power inline [police| priority] [interface-id | module stack-member-number] [detail]
Syntax Description
(Optional) Displays the power policing information about
real-time power consumption.
police
(Optional) Displays the power inline port priority for each port.priority
(Optional) ID of the physical interface.
interface-id
(Optional) Limits the display to ports on the specified stack
member.
This keyword is supported only on stacking-capable switches.
module stack-member-number
(Optional) Displays detailed output of the interface or module.detail
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Examples
This is an example of output from the show power inline command. The table that follows describes the
output fields.
Device> show power inline
Module Available Used Remaining
(Watts) (Watts) (Watts)
------ --------- -------- ---------
1 n/a n/a n/a
2 n/a n/a n/a
3 1440.0 15.4 1424.6
4 720.0 6.3 713.7
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Gi3/0/1 auto off 0.0 n/a n/a 30.0
Gi3/0/2 auto off 0.0 n/a n/a 30.0
Gi3/0/3 auto off 0.0 n/a n/a 30.0
Gi3/0/4 auto off 0.0 n/a n/a 30.0
Gi3/0/5 auto off 0.0 n/a n/a 30.0
Gi3/0/6 auto off 0.0 n/a n/a 30.0
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
115
show power inline

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English