Cisco Catalyst 3650 Series User Manual

vrrp preempt
To configure the device to take over as master virtual router for a Virtual Router Redundancy Protocol (VRRP)
group if it has higher priority than the current master virtual router, use the preempt command in VRRP
configuration mode. To disable this function, use the no form of this command.
preempt [delay minimum seconds]
no preempt
Syntax Description
(Optional) Number of seconds that the device will
delay before issuing an advertisement claiming master
ownership. The default delay is 0 seconds.
delay minimum seconds
Command Default
This command is enabled.
Command Modes
VRRP configuration (config-if-vrrp)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Release 2.1
Usage Guidelines
By default, the device being configured with this command will take over as master virtual router for the
group if it has a higher priority than the current master virtual router. You can configure a delay, which will
cause the VRRP device to wait the specified number of seconds before issuing an advertisement claiming
master ownership.
The device that is the IP address owner will preempt, regardless of the setting of this command.Note
Examples
The following example configures the device to preempt the current master virtual router when its priority of
200 is higher than that of the current master virtual router. If the device preempts the current master virtual
router, it waits 15 seconds before issuing an advertisement claiming it is the master virtual router.
Device(config-if-vrrp)#preempt delay minimum 15
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
203
vrrp preempt

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English