Cisco Catalyst 3650 Series User Manual

ip ttl (ERSPAN)
To configure Time to Live (TTL) values for packets in the Encapsulated Remote Switched Port Analyzer
(ERSPAN) traffic, use the ip ttl command in ERSPAN monitor destination session configuration mode. To
remove the TTL values, use the no form of this command,
ip ttl ttl-value
no ip ttl ttl-value
Syntax Description
TTL value. Valid values are from 2 to 255.
ttl-value
Command Default
TTL value is set as 255.
Command Modes
ERSPAN monitor destination session configuration mode (config-mon-erspan-src-dst)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Examples
The following example shows how to configure TTL value for ERSPAN traffic:
Switch(config)# monitor session 2 type erspan-source
Switch(config-mon-erspan-src)# destination
Switch(config-mon-erspan-src-dst)# ip ttl 32
Related Commands
DescriptionCommand
Configures an ERSPAN destination session and
specifies destination properties.
destination
Configures a local ERSPAN source session.monitor session type erspan-source
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
487
ip ttl (ERSPAN)

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English