•
AutoQos-4.0-Output-Control-Mgmt-Queue (match-any)
•
AutoQos-4.0-Output-Multimedia-Conf-Queue (match-any)
•
AutoQos-4.0-Output-Trans-Data-Queue (match-any)
•
AutoQos-4.0-Output-Bulk-Data-Queue (match-any)
•
AutoQos-4.0-Output-Scavenger-Queue (match-any)
•
AutoQos-4.0-Output-Multimedia-Strm-Queue (match-any)
The following policy maps and class maps are created and applied when running the auto qos trust dscp
command:
Policy maps:
•
AutoQos-4.0-Trust-Dscp-Input-Policy
•
AutoQos-4.0-Output-Policy
Class maps:
•
class-default (match-any)
•
AutoQos-4.0-Output-Priority-Queue (match-any)
•
AutoQos-4.0-Output-Control-Mgmt-Queue (match-any)
•
AutoQos-4.0-Output-Multimedia-Conf-Queue (match-any)
•
AutoQos-4.0-Output-Trans-Data-Queue (match-any)
•
AutoQos-4.0-Output-Bulk-Data-Queue (match-any)
•
AutoQos-4.0-Output-Scavenger-Queue (match-any)
•
AutoQos-4.0-Output-Multimedia-Strm-Queue (match-any)
To disable auto-QoS on a port, use the no auto qos trust interface configuration command. Only the
auto-QoS-generated interface configuration commands for this port are removed. If this is the last port on
which auto-QoS is enabled and you enter the no auto qos trust command, auto-QoS is considered disabled
even though the auto-QoS-generated global configuration commands remain (to avoid disrupting traffic on
other ports affected by the global configuration).
Examples
This example shows how to enable auto-QoS for a trusted interface with specific CoS classification.
Device(config)# interface gigabitEthernet1/0/17
Device(config-if)# auto qos trust cos
Device(config-if)# end
Device# show policy-map interface GigabitEthernet1/0/17
GigabitEthernet1/0/7
Service-policy input: AutoQos-4.0-Trust-Cos-Input-Policy
Class-map: class-default (match-any)
0 packets
Match: any
0 packets, 0 bytes
5 minute rate 0 bps
QoS Set
cos cos table AutoQos-4.0-Trust-Cos-Table
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
610
auto qos trust
To Next Page
Loading...
Need help?
General