Cisco Catalyst 3650 Series User Manual

snmp-server enable traps isis
To enable intermediate system-to-intermediate system (IS-IS) link-state routing protocol traps, use the
snmp-server enable traps isis command in global configuration mode. Use the no form of this command to
return to the default setting.
snmp-server enable traps isis [errors | state-change]
no snmp-server enable traps isis [errors | state-change]
Syntax Description
(Optional) Enables IS-IS error traps.errors
(Optional) Enables IS-IS state change traps.state-change
Command Default
The sending of IS-IS traps is disabled.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples
This example shows how to generate IS-IS error traps:
Device(config)# snmp-server enable traps isis errors
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
543
snmp-server enable traps isis

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English