Cisco Catalyst 3650 Series User Manual

show ip igmp snooping mrouter
To display the Internet Group Management Protocol (IGMP) snooping dynamically learned and manually
configured multicast router ports for the device or for the specified multicast VLAN, use the show ip igmp
snooping mrouter privileged EXEC command.
show ip igmp snooping mrouter [vlan vlan-id]
Syntax Description
(Optional) Specifies a VLAN; the range is 1 to 1001 and 1006 to 4094.
vlan vlan-id
Command Modes
User EXEC
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP snooping.
When multicast VLAN registration (MVR) is enabled, the show ip igmp snooping mrouter command displays
MVR multicast router information and IGMP snooping information.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output do not
appear, but the lines that contain Output appear.
Examples
This is an example of output from the show ip igmp snooping mrouter command. It shows how to display
multicast router ports on the device:
Device# show ip igmp snooping mrouter
Vlan ports
---- -----
1 Gi2/0/1(dynamic)
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
257
show ip igmp snooping mrouter

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English