Cisco Catalyst 3650 Series User Manual

show platform software swspan
To display switched port analyzer (SPAN) information, use the show platform software swspan command
in privileged EXEC mode.
show platform software swspan {switch} {{{F0 | FP active} counters}| R0 | RP active} {destination
sess-id session-ID | source sess-id session-ID}
Syntax Description
Displays information about the switch.switch
Displays information about the Embedded Service Processor (ESP) slot
0.
F0
Displays information about the ESP.FP
Displays information about the active instance of the ESP or the Route
Processor (RP).
active
Displays the SWSPAN message counters.counters
Displays information about the RP slot 0.R0
Displays information the RP.RP
Displays information about the specified destination session.
destination sess-id session-ID
Displays information about the specified source session.
source sess-id session-ID
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was introduced in a release prior to Cisco IOS XE
Denali 16.1.1.
Cisco IOS XE Denali 16.1.1
Usage Guidelines
If the session number does not exist or if the SPAN session is a remote destination session, the command
output will display the following message "% Error: No Information Available."
Examples
The following is sample output from the show platform software swspan FP active source command:
Switch# show platform software swspan FP active source sess-id 0
Showing SPAN source detail info
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
529
show platform software swspan

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English