Cisco Catalyst 3650 Series User Manual

queue-limit
To specify or modify the maximum number of packets the queue can hold for a class policy configured in a
policy map, use the queue-limit policy-map class configuration command. To remove the queue packet limit
from a class, use the no form of this command.
queue-limit queue-limit-size [packets] {cos cos-value| dscp dscp-value} percent percentage-of-packets
no queue-limit queue-limit-size [packets] {cos cos-value| dscp dscp-value} percent percentage-of-packets
Syntax Description
The maximum size of the queue. The maximum varies
according to the optional unit of measure keyword
specified ( bytes, ms, us, or packets).
queue-limit-size
Specifies parameters for each cos value. CoS values are
from 0 to 7.
cos cos-value
Specifies parameters for each DSCP value.
You can specify a value in the range 0 to 63 specifying
the differentiated services code point value for the type
of queue limit .
dscp dscp-value
A percentage in the range 1 to 100 specifying the
maximum percentage of packets that the queue for this
class can accumulate.
percent percentage-of-packets
Command Default
None
Command Modes
Policy-map class configuration (policy-map-c)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
Although visible in the command line help-strings, the packets unit of measure is not supported; use the
percent unit of measure.
This command is supported only on wired ports in the egress direction.Note
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
658
queue-limit

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English