Cisco Catalyst 3650 Series User Manual

interface range
To configure an interface range, use the interface range command.
interface range {Gigabit Ethernet interface-number | Loopback interface-number | Port Channel
interface-number | TenGigabit Ethernet interface-number Tunnel interface-number Vlan
interface-number Macro WORD}
Syntax Description
Configures the Gigabit Ethernet IEEE 802.3z interface. Values
range from 1 to 9.
GigabitEthernet interface-number
Configures the loopback interface. Values range from 0 to
2147483647.
Loopback interface-number
Configures 10-Gigabit Ethernet channel of interfaces. Values
range from 1 to 128.
Port-Channel interface-number
Configures 10-Gigabit Ethernet interfaces. Values range from 0
to 9.
TenGigabit Ethernet interface-number
Configures the tunnel interface. Values range from 0 to
2147483647.
Tunnel interface-number
Configures the switch VLAN interfaces. Values range from 1 to
4095.
VLAN interface-number
Configures the keywords to interfaces. Support up to 32 characters.
Macro WORD
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Examples
This example shows how you can configure interface range:
Device(config)# interface range vlan 1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
44
interface range

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English