Cisco Catalyst 3650 Series User Manual

If a switch is shut down because of load shedding, the output of the show stack-power command still includes
the MAC address of the shutdown neighbor switch. The command output shows the stack power topology
even if there is not enough power to power a switch.
Examples
This is an example of output from the show stack-power command:
Device# show stack-power
Power Stack Stack Stack Total Rsvd Alloc Unused Num Num
Name Mode Topolgy Pwr(W) Pwr(W) Pwr(W) Pwr(W) SW PS
-------------------- ------ ------- ------ ------ ------ ------ --- ---
Powerstack-1 SP-PS Stndaln 350 150 200 0 1 1
This is an example of output from the show stack-power budgeting command:
Device# show stack-power budgeting
Power Stack Stack Stack Total Rsvd Alloc Unused Num Num
Name Mode Topolgy Pwr(W) Pwr(W) Pwr(W) Pwr(W) SW PS
-------------------- ------ ------- ------ ------ ------ ------ --- ---
Powerstack-1 SP-PS Stndaln 350 150 200 0 1 1
Power Stack PS-A PS-B Power Alloc Avail Consumd Pwr
SW Name (W) (W) Budgt(W) Power(W) Pwr(W) Sys/PoE(W)
-- -------------------- ----- ----- -------- -------- ------ -----------
1 Powerstack-1 350 0 200 200 0 60 /0
-- -------------------- ----- ----- -------- -------- ------ -----------
Totals: 200 0 60 /0
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
122
show stack-power

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English